Stack two pieces of 3/4-in. Plywood and screw them together with 1-1/4 in. Mark the vise-mounting holes on the plywood and drill 3/4-in. Guide holes through both pieces.
- If you have to pick up long lengths of wood from the lumberyard, throw a spring clamp in the back of your vehicle.
- At this point, the wood fibers are absorbing the water and should expand back to where they were originally.
- Some quarter-sawn boards, especially those of white oak, exhibit gorgeous rays or flecks; a hallmark of much Craftsman-style furniture.
- A couple boards and some nails might work, but they may not be the best solution to keeping your project in one piece.
- Now, with your iron on its highest setting, place it on the damp washcloth over the affected area, and make small movements back and forth and in circles.
- Also, don’t forget to check out these carpentry tips and tricks.
Recess the nut by drilling through the bottom sheet with a 1-in. Spade bit using the 3/4-in. Fasten the vise to the plywood with bolts sized to match the vise-mounting holes.
It’s often used as shelving or as an underlayment for carpet. Plastic laminate may be applied to both sides to create a product that can be used to create everything from furniture to cabinets to wall paneling. Head into IKEA and you’ll find acres of particleboard. Can awl of us find our awl when we need it? Grab an old, battered Phillips screwdriver and grind the tip into a sharp cone shape on a bench grinder.
And because the shelving units are made of plastic, I can cut right into them without worrying that they’ll damage my saw blade. Particleboard is a manufactured wood product composed of sawdust, wood chips or wood shavings mixed with a resin. This concoction is layered, compressed, subjected to heat and cut to shape, resulting in a sheet material that can be used for a variety of things.
Instead, I use a wide, sharp chisel. This way, I can read the grain direction and trim accordingly. Angle the chisel slightly and go slow, raising the back corner of the chisel just enough so that it doesn’t dig into the plywood veneer.
Join us in the workshop for live events and Q&A sessions that give you special access to our https://bestwoodcarvingtool.com/best-hand-planer/ experts! Check out our live events and learn something new today. When face-gluing boards, use a credit card snipped along its wide edge with a pinking shears.
We’ve got thousands of articles and videos from experts geared to make you a better woodworker. Also, don’t forget to check out these carpentry tips and tricks. Get complete site access to video workshops, digital plans library, online archive, and more, plus the print magazine.
It sounded like an old wives’ tale, but I tried it and found it really works. A curated collection of how-to, plans, and projects from woodworking experts you can trust. Sign up for Woodworking in America right here. Use coupon code Guild50 for a discount. Find all of the ShopNotes podcast episodes here.
If the board edges are quite bowed or curvy, you may need a second pass. If so, unscrew the cleats, reclamp the boards across the middle center, then screw on the cleats again. The screws ding up the ends of the boards a little, so cut the boards you’re jointing a bit long, then trim 1/2 in. From each end to remove the screw holes. Instead of using a container to mix a small amount of epoxy, just make a mixing surface on your workbench using painters tape. Simply lay down strips, overlapping the edges so the epoxy doesn’t get on your bench.